30 gram filament spiral

thingiverse

This is 30 grams or 10.10 meters of custom printable filament. The filament diameter is 1.75mm, which should work on most FDM printers. You can run this in spiral mode, but you don't have to. Print time is 1hr 18minutes. Just pause the print or do a color change whenever you want. Results will vary. I also added some support to the ends of the coil as the outer end of the coil would come off the bed half-way through printing. Just clip the ends off and use. If you have flow problems, part prints part-way then stops extruding but continues printing, then turn up your flow rate. Shouldn't need higher than 150% if at all.