30° angle 31.5cm long 12.5mm wide LED strip mount (sized for IKEA EKET)

prusaprinters

<p>I wanted an angled LED strip mount to light up the inside of my IKEA EKET cabinet from the front and hide the strip for a tidy look.</p><p>Found the original model, played around with it in Blender to extend it to cabinet's inside full length and resized to fit a smaller LED strip (I have one that's 12.5mm wide including its water-protective cover).</p><p>Worked well. Strip in its protective wrap is easily friction-fit into the mount. Needed to cut out a bit of the mount on one side to make space for the cable but that's it. Be careful as you may snap off too much if you're not careful (superglue to the rescue, fortunately it wasn't on the visible side)</p><p>NOTE: Model has some geometry errors which I couldn't be bothered to fix, but slices and prints perfectly fine in Cura in my experience.</p><p>For smaller print beds &nbsp;like my Ender 3 you might have to print it at an 45-degree angle to fit. Print with 3 walls and I strongly suggest using support at least the first 30% (or some parts) of the print as it gets very wobbly towards the end.</p>