3 Powerbank Charging Station

prusaprinters

<p>My family constantly needs to charge their devices on the go. My 7-port USB charger gets a daily workout charging all of them!&nbsp;</p><p>Before this, I just kind of stacked them in a pile next to the charging station. I thought that was unsightly, so I made this. My family can just put a powerbank into this holder, plug up a cable, and not worry about knocking over a pile of powerbanks. It should accommodate any power bank up to 80mm wide and 25mm thick. I tried to make the holders tall enough to accommodate long powerbanks that might tip over if stored vertically.&nbsp;</p><p>I printed it in Eryone Red PLA, .28mm layer height, 3 perimeters, 5% infill. Not a lot of infill is needed-- walls are most important. No support is needed. PETG might be a better option. Share your makes!&nbsp;</p>