3 point hose cart holder - Gardena compatible

thingiverse

When unrolling the hose, the hose cart always rolled away or tipped over. This became too annoying for me and so I had the idea to simply fix the cart to the wall. For this purpose I designed brackets into which you can hang the hose cart. I recommend printing 3-4 holders - two for the handle and 1-2 for the stand. The holders are designed for a diameter up to 21 mm. In my case, I use a Gardena hose cart but it should also be usable for other carts. The distances of the brackets must be adapted individually to the cart. There are three holes for screws. First, use the upper two to screw on, align and tighten. Then fix the bracket with the lower hole. For use with the cart, first clip the bottom of the stand in place, then hang the handle on top. The cart will then be held in the brackets by its own weight. In addition, "anti-slip noses" are attached so that the cart does not slip out by itself when pulling on the hose. If you find this part useful, you're welcome to leave a small donation. Have fun with it!