3 inch duct 90 degree mount for snapmaker enclosure exhaust

thingiverse

Flange to reduce the amount of space required around the snapmaker enclosure (in my case A250T). A slimline 90 degree exhaust vent to connect the supplied 3 inch ducting to.I suspect it will fit all snapmaker enclosures as long as they have the same 3 inch ducting. Hole centres mean that it will also fit directly on to an 80mm fan although the flat face is larger than required so there may be better models for that.Use the enclosure supplied bolts and simply replace the supplied duct flange with this one pointing in which ever direction suits you. Ensure you put the fan back in the correct orientation, label pointing outwards.I printed in PLA, fast speeds and 15% infill.It used 74g PLA + 50g support PLAThe final pic shows you why I have been obsessed with reducing the footprint around the enclosure, mm by mm. With the vent connected I couldn't open the left hand door. Obviously for most people the vent will most likely point up or to the side rather than down.I may divide it in 2 across a 45 degree glueable plane to make it WAY more filament/time efficient, perhaps if this one breaks :)