3-in-1 Phone, Watch, and Airpods Charger Dock

prusaprinters

<p>This charging dock is a 3-in-1 dock for the Yootech wireless charger (linked below), apple watch (40/42mm), and 2nd generation airpods. It's a relatively straightforward print with minimal supports. Check the screenshot of the sliced file for support locations.</p><p>Some caveats about the design:&nbsp;</p><ol><li>The width of the phone (including case) must be less than 80mm to fit!!</li><li>the apple watch charger cable needs to be one of the new ones with the USB-C end in order to install it - there is a slot only big enough for the USB-C adapter to feed the cord through to the bottom side of the dock.</li><li>To get the airpods charge cable to work properly i.e. not pull the cord out when you try to pull the airpods out of the dock, you have to feed the cord through the rear-most channel in the base. It's sort of a tight fit to get it around the bend, but that's what holds it in place.</li><li>To install the airpods charger cable correctly, you slide it up through the channel in the base and then rotate it 90 degrees and pull it back down to fit snugly in the small cutouts in the side of the channel.</li></ol><p>I also included the STEP file if you want to make minor design changes. As always, I designed the tolerances for this dock with my specific printer's capabilities in mind.</p><p>***If you have any special requests for other wireless chargers, airpods cases, etc. just shoot me a message and I can modify the design to fit your needs for a small fee.</p><p><a href="https://www.amazon.com/gp/product/B079KZ49PJ/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&amp;th=1">https://www.amazon.com/gp/product/B079KZ49PJ/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&amp;th=1</a></p><p>&nbsp;</p><p>&nbsp;</p>