3 in 1 buse cooling for BQ Hephestos 1

thingiverse

This part increases air flow, cools PTFE, and illuminates the print area. Easy to remove by hand using a connector included with the parts. These parts are designed to be printed with a 0.4mm nozzle, but with a 0.2mm nozzle the results will be even cleaner. You can find the assembly and kit here http://premium-forum.fr/viewtopic.php?f=9&t=1141 Temperature measurements can be found at http://premium-forum.fr/viewtopic.php?f=9&t=1064&p=8828#p7365 Also check out the remix, an evolution of these parts. Print Settings Printer: Hephestos Rafts: No Supports: No Resolution: 100µ Infill: 20% Notes: Supports are included Print with good PLA (Innofil) Post-Printing Leds Lighting consists of 2 x 3 white LEDs, 3mm in size, mounted in series with a 150 ohm resistor per group of 3 LEDs. Mount the LEDs on a test plate by cutting the leads off at the circuit before soldering them. Each group of 3 is connected to the 12V of the extruder fan. There are no cables to pass through, just solder the two wires before the fan connector (this allows the fan to be removed without desoldering the wires). Respect the polarity of the LEDs (long lead connected to short lead of the next one and so on). The cable that goes to the LED groups must be very thin, about 0.8mm with the sheath. Guidance inside the arms is facilitated by using a semi-rigid plastic wire tie. The parts kit can be found here https://boutique.premium-computer.fr/shop/imprimantes/kit-tobera-led/ Update to come Removal of the screw that will be replaced by a magnet In a few days I will post a new design that allows you to get rid of the screw thanks to an adapted magnet included in the LED kit. I've tested it, and it holds perfectly in place, faster and even more practical. It's here https://www.thingiverse.com/thing:1706952