3/8-16 10mm height

thingiverse

Using the following options: Created With: Thingiverse Customizer http://www.thingiverse.com/apps/customizer/run?thing_id=193647 Instructions: Make This! Created using: http://www.thingiverse.com/thing:193647 slot depth: set to 2 facets Set facets count to 6 drill size set to 5 socket style Nut flat edges 45 degree mark on countersinks set to 2 bolt head length of 5 thread size zero no taper no shoulder bolt diameter when not threaded, no taper zero thread shoulder thickness at widest point of 2 hole inner wall 1 wing span drill from center hole of 8 full round outer circumference of 14 nut width outside to countersinks 0.5 spacing on both sides equal thread length at end 25 millimeters thread increment by step of 1.525 mm non-thread length on bolt shaft, no shoulder zero no taper at head and nut bottom diameter size set to 9 resolution for render: 0.5 slots 1 mm deep drive tool from inner side hole, no taper flat washer flat nut edge mark