3-6-9 Block

prusaprinters

<p>If a <a href="https://www.printables.com/model/34324-1-2-3-block">1-2-3 block</a> is good then a 3-6-9 block must be three times better! This was mainly just me playing around with OpenSCAD but I figured I'd upload it in case someone is crazy enough to make it.</p><p>Note that the included SCAD file can be used to make more reasonably sized versions like a 1-2-3.</p><h3>Design</h3><p>Created in OpenSCAD (source included). The length of each side, the hole diameter and the number of holes along each axis are adjustable parameters.</p><h3>Slicing</h3><p>Are supports needed? I hope not ‘cause it would be a pain to dig them out of the center of this thing. Run with whatever nozzle diameter and layer height you feel like.</p><h3>Printing</h3><p>Load up a completely full spool (at least 1KG), start the print and go on vacation for a week. When you get back it <i>should</i> be done.</p>