3.5" Touch Screen Mod for Prusa Mk2/2s/3/3s (LCD LEFT)

thingiverse

3.5" Touch Screen Mod for Prusa Mk2/2s/3/3s LEFT LCD I made this modification because my original LCD TFT wouldn't rotate 180 degrees, so I decided to try something new. You will need to give up your SD card slot from the Prusa original board in order to install this mod. To be honest, this was one of the most challenging prints I've ever done. It took me around twenty attempts to get it just right, and even then, it wasn't perfect. The first layer that covered the entire print bed was a particular challenge - it took some trial and error to get it looking good. I found that slicing with Prusa Slicer resulted in a much better extruder route than using Cura, even when I used the same parameters. It's definitely worth trying if you're having trouble getting your prints just right.