$3.49HEPA + Charcoal Filter Housing For Fume Extraction

myminifactory

I designed this fume extraction unit for exhausting ABS from my enclosures using affordable HEPA air filters and charcoal filters paired with a powerful 50mm fan to get the job done! It can fit any wall thickness by simply varying the length of securing screws. Easily printable with minimal supports (on 90-degree overhang only). Printed in three pieces for aesthetics and ease of assembly. Parts required: (Note: Using these links supports me with Amazon's affiliate program!) HEPA Filter (Comes in pack of four) https://amzn.to/2rXPLUJ Charcoal Filter (Cut to fit) https://amzn.to/2LrsSja 12V Fan https://amzn.to/2YhUwEE OR 24V Fanhttps://amzn.to/2Pncqls SPST Toggle Switch https://amzn.to/36aoWLR Recommended: Heat-Set Inserts and hardware for M3 & M5 screws (See Pictures) https://amzn.to/2rhpZL2 Assembly: 1. Install heat set thread inserts. 1A. Install toggle switch. 2. Mate ENCFANBODY to ENC BODY with M5 Screws. 3. Cut charcoal filter to size and slide it in the slot closest to the fan. 4. Slide in HEPA filter. 5. Install ENCLID with M3 screws. 6. Cut a hole in the enclosure wall/roof to match 50mm fan diameter (don't forget a slot for wires to pass through!). 7. Install filter housing. The enclosure wall is sandwiched by the filter housing and fan (with the fan on the inside). 8. Enjoy a clean, safe, and odor-free printing environment! After a print finishes, turn on the exhaust fan to clean the air within the enclosure and cool down the printer faster. Allow 10 minutes before opening the door (this time will depend on the size of the enclosure).