3/4" PVC Pipe Clip

thingiverse

This clip is designed specifically for 3/4" PVC Pipe, featuring a slotted recessed hole tailored to accommodate a #8 pan head screw. The standard model boasts an impressive 16 mm height from the bottom of the pipe to its base, with the top of the pipe sitting approximately 1-5/8 inches above the base. In September 2019, I introduced a modified version that features a wider gap at the top, making it easier to snap onto PVC pipe. This upgrade was necessary due to the increased brittleness of my current filament, which often cracked when snapping onto the pipe. The tall version takes it up a notch by adding an extra 8 mm to its height and boasting a deeper screw recess. As a result, the top of this model sits a full 2 inches above the base. Lastly, I created the tall-wide version, which boasts a 4 mm increase in width over the standard tall version. This design was specifically tailored for use in mortar joints within brick structures, where a wider clip is necessary to ensure secure fastening.