3/4" J Channel Jig for 12mm Pixels

prusaprinters

<p>This is for the 3/4" J channel that I got from Menards. This is for the 12mm RGB Pixels.</p> <p>Currently, 2" center spacing.</p> <p>The "short" jig saves plastic and printing time but will only do 2" and 4" spacing.</p> <p>You can use the outer cut to align with your drill bit.</p> <p>The size tester is a small print so you can test your j channel with how this jig is designed.</p> <p>Print vertical, no supports needed. Print at least one pin for alignment. I do check detect bridging parameters in Prusa Slicer.</p> Category: Other