3.0mm-0.3mm Lithophane Calibration Tower

thingiverse

All different filaments I use for lithophanes don't always work at typical 0.6mm min/3.0mm max thickness, so I needed a quick way to evaluate filaments that didn't require much time or material. Thickness ranges from 3.0mm up to 0.3mm thick. Dots/holes show the steps that are whole integers (3mm/2mm/1mm). Steps decrease evenly going up between dots/holes, so from 3mm up to 1mm, steps are 0.2mm apart, and above 1mm, steps are 0.1mm apart. Available for modification at: https://www.tinkercad.com/things/bXnX3GSs9Xa-30-03lithocalibration Included is the Gcode for a Ender 3/Ender 3 Pro using Gudunky's lithophane Cura profile. It prints in about half an hour.