2x2 Deck Box

thingiverse

This is my first actual upload, just wanted to share my (Re)creation.This is my recreation (remix might be a stretch, but still tagged it as such) of Intentional3D's Triple Deck Box.My first publicly shared creation; made from scratch (with the exception of the loop and holder) but based/inspired entirely on Intentional3D's Triple Deck Box.The Slider and Case I designed into a 2 by 2 square configuration to hold 4 100 card MTG decks.I included some recessed slots on inside of the case to glue in some magnets paired with the gluing of a thin sheet of metal to the Slider so the thing is held shut and could actually be carried by the loop or even accidently lifted upside down without dropping everything.Also slightly modified the holder to better hold the decks.I literally just imported scaled the Original loop as it was too complicated of a shape for me to make from scratch with my limited skill/tools, and separated it from the slider to help reduce artifacts that would appear on the slider and make it easier to paint/post process the whole thing, can be glued back on using a 1/8 x 3/4 in tension pin.Magnets used: 60 x 10 x 3 MM Bar Magnets: https://www.amazon.com/gp/product/B08GCVBCZM/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1Sheet Metal for Slider 0.012 inch think metal sheet: https://www.amazon.com/gp/product/B000BPK6VW/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1For reconnecting the Loop I used 1/8 x 3/4 in Tension Pins. Original link or seller not available but this is what it is: https://www.amazon.com/Hard-Find-Fastener-014973222864-Piece-36/dp/B00OQ8XKN6/ref=sr_1_4?crid=V8O8B5E29SHX&keywords=1%2F8+x+3%2F4+tension+pin&qid=1699398339&sprefix=1%2F8+x+3%2F4+ten%2Caps%2C172&sr=8-4Mine is printed in Amazon Basics PETG with some post processing and painting tricks to make it look nice.No Supports needed for Slider and Case.Holder should only need Supports for the gap in the wall.Loop can be printed upright, but you will want to use a brim and supports.My loop is not currently connected in pictures cause I originally printed mine in Resin and it broke (even though I used a flexible mix, resin is just too brittle), and I still need to process a new one out of PETG.