2x Monitor Stand / Riser (200 and 280mm)

cults3d

This is a fairly straightforward monitor stand. The only challenge was making it printable, so I divided it up in two parts (top and bottom) that you can click together to create the stand. If you want it higher or lower I would suggest you in/decrease the z %, I haven't tested that but I guess that would work. Note that the thing is fairly big 28cm in x direction, so only suited for big printers. HOWEVER if you have fusion 360, you can dowload the f3d file and make the necessary adjustments. UPDATE: New stand 200mm My wife wanted a stand as well, so I created one for her monitor, quite different in some aspects as she wanted a shielded section where she can place her USB hub and entries for the cables. Next to that the top is open (in contrast to the 280mm version where the top is closed), this so her monitor stand can 'sink' inside the inner section. As usual, fusion files have been added. UPDATE: Added an '19mm height adjuster' for the 280mm version which you can use to raise the height of the stand with an additional 19mm (or a multiple of that as you can stack them!)