2x Macbook Pro Retina Stands

thingiverse

I cloned the original design to enable me to print enough supports for my laptop at one go on my painfully slow printer. It took 8 hours to M3D print these two models on medium quality. These fits both 13-inch and 15-inch Retina MacBooks Pro perfectly. I've successfully enlarged them in my slicer to fit non-Retina models as well. However, I would not make them thinner to accommodate an Air model. Printer Settings: M3D Micro printer settings: Rafts: No Supports: Yes Resolution: 200 microns Infill: Medium Notes: Wave bonding is enabled. It creates a surface incredibly sticky, and unfortunately, this resulted in the entire bottom layer tearing off one of my previous models but did not cause any shifting issues as I experienced with rafts so I'll accept that compromise for now.