2x 18650 Battery Case, Storage, Holder, Batteriegehäuse

thingiverse

The version for 18650 batteries is now available at http://www.thingiverse.com/thing:1421921. This is a straightforward, lightweight, and fast to print battery case designed specifically for two 18650 cells, whether protected or unprotected. No magnets or additional caps are required. The customizable design was created by "anewsome". To determine the dimensions of your printed case, refer to the instructions below (width, height, depth) and check the size of your batteries before printing. If they do not fit, use these values as a reference to adjust the battery size. Printed with the recommended settings found at http://www.thingiverse.com/thing:82533. The printed case requires approximately 2.90 meters of material (2.85 mm), weighing about 23 grams. This design was created using Customizer! Try it yourself at http://www.thingiverse.com/apps/customizer/run?thing_id=82533. Print Settings: Printer Brand: Ultimaker Printer: Ultimaker 2 Rafts: Doesn't Matter Supports: No Resolution: 0.15 mm Infill: 100% Notes: This design was printed with PETG and a nozzle size of 0.4 mm. PLA/ABS should also work well. Instructions: To use the following options, enter these values into Customizer: fingerSize = 6.5 height = 11 depth = 41 z = 0 hingeOuter = 7 hingeFingerSlop = .4 wallThickness = 1.5 hingeInnerSlop = .4 $fn = 100 latchWidth = 15 width = 76 hingeInner = 4