2S Lipo Battery Holder - 16mm x 16mm - RakonHeli 66mm Brushless Whoop

thingiverse

I quickly wore out the original RakonHeli 2S battery holder after using it with a couple dozen batteries, so I decided to create my own custom design. The battery slots in my model are sized to fit snugly around 260HV batteries, allowing them to slip in easily. Although the fitting isn't extremely tight, the batteries still stay securely within the holder. A few tips to keep in mind when printing this model: -The orientation of the model can be either as-is or rotated 180 degrees; however, depending on the chosen orientation, you may need to add extra supports. -Make sure to print with a layer height between .1-.15mm; smaller is better for optimal results. -Use supports that fill at least 50% of the supported area to ensure stability during printing. -You can use any type of flexible filament, such as TPU or Ninjaflex, to achieve the desired flexibility. -Print at a slower speed than usual; this model was printed at 2200mm/min X/Y axis and 1200mm/min on the Z axis. If you have any questions or comments, please leave them below, and I'll get back to you promptly.