2S JST balance connector grip

thingiverse

Grip firmly in place to simplify extracting the 2S JST balance connector from chargers. Print the components, separate them using slicer software and lay them flat on the bed. Once printed, position the top and bottom shells over the connector and snap them together securely, then hold them in place with a wrap of electrical tape or heat shrink (22mm un-shrunk) around the entire grip body to keep it intact. This grip works seamlessly with Syma x8C X8HC X8W X8HW X8G X8HG or any standard 2S battery pack featuring a JST style connector (3 pin). Note: This grip is compatible with all connectors that came with various batteries shown, but does not fit replacement connector housing purchased from an overseas source - possibly due to non-compliance with specifications. If they fit, the connectors should click firmly into the grip shell; if this isn't the case on your connector, use a sharp knife to trim some material off the connector body for a proper fit.