2mm GT2 Pulley 30 tooth

thingiverse

Join the Subreddit: https://www.reddit.com/r/EngineeringNS/ Customized version of http://www.thingiverse.com/thing:16627 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the following options: m3_nut_depth is set to 2.7, no_of_nuts is zeroed out, pulley_b_ht is adjusted to 2, idler_ht is precisely calibrated at 1.5, nut_shaft_distance is narrowed down to 1.2, nut_angle is locked in at 90 degrees, retainer is enabled with a value of one, profile is optimized for two settings, retainer_ht is set to one unit high, teeth are configured for thirty units, additional_tooth_width is increased by 0.2 units, idler is turned off with a value of zero, motor_shaft is lengthened to 16.4 units, m3_nut_flats are precisely measured at 5.7 units, pulley_t_ht is heightened to 8 units, additional_tooth_depth is adjusted to 0.2 units, m3_nut_hex is calibrated at one unit, and m3_dia is set exactly at 3.2 units, while pulley_b_dia is precisely measured at 22 units.