28 mm Dual cannon turret

thingiverse

This is a 28mm dual cannon turret top compatible with my 28mm retribution turret base (found here https://www.thingiverse.com/thing:1433038) and a future release of mine for more fortifications, as well as many actual 40k fortifications. This model comes equipped with options for both laser cannons and normal cannons as primary armaments. For a complete print out the following parts: -1x base plate -2x side walls -2x front-back walls -1x turret rotation part 1 -1x either turret rotation part 1 cannons or turret rotation part 1 lasercannons Minor edits to the base plate and side walls are recommended for a better fit. Anyone with older downloads will still be able to use them but may need minor filing in the connection pieces due to heat shrink. Print Settings: Rafts: Does not matter Supports: No Resolution: .2-.1 Infill: 10-20% Notes: Active cooling is recommended, and side walls should be printed on .16 or lower for better quality. Post-Printing: Prep and Assembly: Standard fill and sanding are necessary to clean up the appearance. Glue turret rotation part 1 and 2 together with super glue after roughing up contact surfaces to ensure a better adhesion. The tabs that connect the parts together and rotate within each other will likely need sanding to fit properly. It is recommended to perform dry fitting all parts prior to any gluing. Assembly: Glue both front and back pieces to one of the side walls. Then place the rotation part in its place on the side piece you have glued the front and back pieces to. Finally, glue the other side piece to the front and back pieces ensuring the rotation piece properly rotates.