27mm Quick Fill Funnel

thingiverse

Sorry for the subpar photos. This is a 27mm quick fill funnel that gets the job done fast. What makes it so speedy? It's not just the compact size, but also its clever design that lets air escape as you pour liquid into the funnel. The walls are an impressive 1.6mm thick, allowing you to shrink it down to half its original size and still have a fully functional funnel. Scaling it up should be no problem either. One thing to keep in mind is that PLA can warp when exposed to excessive heat. Don't even think about tossing this funnel in the dishwasher or using scalding hot water to clean it. And please, don't use this funnel for food prep - 3D prints are not considered safe for human consumption. **Print Settings** * Printer Brand: MakerBot * Printer: MakerBot Replicator 2 * Rafts: No rafts required * Supports: None needed * Resolution: 0.32 * Infill: 100% **Post-Printing** To get rid of the raft, gently push it off with your thumbs by applying pressure and pushing it away from the funnel. Next, place a sheet of sandpaper on a flat surface and drag the area where the raft used to be over it to create a smooth finish. **Design Details** This design was created using Autodesk Inventor Professional 2016.