25mm Base Movement Tray .5" Cohesion

thingiverse

I'm combining my first 25mm movement tray with max unit cohesion in practice. The closeness can sometimes be an issue when models tend to stretch out. I'll upload a case soon to help pack the models, probably over the weekend. I made a case with magnet slots that you'll need to seal shut using glue, epoxy, a 3D pen, or any other locking method you prefer. Just make sure to triple check polarity before sealing. I used tape for the dry run just in case. The magnets I'm using are 15 x 6.5 x 3 mm and can be purchased from Amazon. There are two versions of the case available: one with holes (air) and one without (solid). The printing time is only slightly shorter with the Air Version, but it does require a few grams less plastic.