25mm/1-inch Suppressor Wipe cutter

thingiverse

All NFA rules apply. Under current regulations, an end-user can create replacement parts, yet this means destroying one and making one in sequence so that they never have more than the original number of suppressor wipes for the design. You cannot make "spares" in preparation ahead of time. Old wipes must be destroyed by cutting them into at least three pieces. Applications: I believe the Thompson Machine Poseidon, GemTech Aurora/Aurora 2, and GSL Boss all use one-inch wipes. A polyurethane/urethane suppressor wipe cutting tool for one-inch wipes, preferably transparent/translucent polyurethane/urethane, is required. It consists of two pieces, a base and a cutter holder. The base can be used separately as a guide or holder. After destroying one wipe, cut your replacement wipe, probably with a one-inch punch, then place the wipe on the base. You can use a regular XActo now and free-hand it using the guide. If you use the cutter, align the four blades to match the cutting guide cross/X, then slowly press down to ensure it's not snagging or that the view you had in starting the X was off due to distortion. Don't "hammer" it. Then use a thin tool to work the wipe off the cutting blades, if you use your hands, you'll probably cut yourself. Caliper blades work really well for this, assuming you have one laying about. You can also use a pocket knife blade but you'll have to slowly work around to each wedge to wiggle it off the cutter.