250 Quade Racer

thingiverse

Tested 8/25: Flies like a Blazing Gorilla! Haven't attached the Fatshark or Gopro Session yet, but I'm confident it will still perform and pack plenty of power. Here are the parts used below: Turnigy 3-cell 2200mah Emax 15-amp ESC ARRIS 1806 2300kv Brushless motors KK2 Flight Controller (also set up to run DJI Naza light) Spectrum 6-channel Receiver 5045 Genfan props COMPLETED 8/18/16 : Finished Printing complete. Adding Hardware and Electronics. Added landing gear. Landing gear optional or you can use four points when installing the upper slab and utilize 3-inch bolts as shown. Quad Arms: .2 Resolution, 75% Lateral Infill, w/Supports, No Raft Lower Slab: .2 Resolution, 40% Infill, No Supports, No Raft Upper Slab: .2 Resolution, 40% Infill, No Supports, No Raft Landing Gear: .2 Resolution 100% Infill w/Raft and Supports Both Canopies: .2 Resolution, 10% Infill, W/Raft and Supports UPDATE 8/15 Printed well had to make some changes to the motor mounts. Updated original design. UPDATED: Just finished design and have not printed. Will update once kinks are worked out if any. ADDED: .thing and .x3g Files