24v led lighting system with on-off lever button, for hotend, on BLV linear rail kit on Aquila x2 voxelab

thingiverse

24v leds lighting system with on-off lever button, for hotend, on BLV linear rail kit on Aquila x2 voxelab, with extruder Sprite Extruder Pro Kit 300℃ convenient modification. I made some improvements on my Aquila x2 for a personal whim, among these I added 24V LED lighting, using the fan connector marked Fan1 on the sprite board. Unfortunately creality used on Sprite Extruder non-standard fan connectors. I had to buy the exact connectors i.e. Micro JST 1.25MM Male/Female 2 Pin connector, as stock fans use this type. At the same time I replaced the original 30mm fan with a less noisy one because the stock one vibrated, so I made the connections you see on the attached photo on the non-original fan. The sprite control board uses these 1.25mm micro connectors for the fans and the thermal sensor, while for the thermal resistance the standard one with a 2.54mm pitch. The voltage of Fan1 must be used to power the LEDs, as there is always power on both poles, while the other connections during use of the printer are disconnected from the negative pole. While connecting the negative and positive to Fan1 in parallel and a switch with the LEDs in series, they turn on or off, for the connections follow the diagram as already mentioned in the attachment. I have attached the photos of the connectors and the switch, you can find them on amazone, for the 24v leds you can also find them at the shop near house, I hope in the auto sector, otherwise online. To connect the molded pieces, longer screws must be used and in the case of the switch cover also a diameter measurement of 2.5. Anyway this is my contribution with this idea, if someone likes it or it will be useful because it has the same kit I will be happy. my modifications on Aquila x2 are: BLV linear rail kit ender 3 pro Sprite Extruder Pro Kit 300℃ MRiscoCProUI-2.1.3d-2c firmware