20mm spool adapter i3 plus

thingiverse

This is a custom adapter designed specifically to convert 20mm center hole filament spools to fit perfectly on the i3 plus 30mm spool holder. **Print Settings** * Printer: Wanhao Duplicator I3 Plus * Rafts: None Required * Supports: Not Needed * Resolution: Adjustable from 0.2 to 0.3 millimeters * Infill Percentage: Set at 15% **Printing Notes** The adapter prints flawlessly with FlashForge filament, and optimal results are achieved when printing at a temperature of 210 degrees. **Installation Instructions** To install the adapter, simply place the square component into the Wanhao Duplicator I3 Plus spool holder. Next, carefully position the 20mm spool onto the round part of the adapter. Finally, secure everything in place using the provided nut, leaving enough room for the spool to rotate freely.