2040 Extrusion Tablet Holder

prusaprinters

<p>Tablet mount offset to one side, intended for 2040 extrusion. This was designed for a tablet approx. 239 mm in length. I have included two versions:</p><p>A split version that allows for printing in parts and assembly with epoxy and screws. That's the version I used in my images and has been holding strong for about 8 months.</p><p>A one-piece version for faster setup, but more difficult to print.</p><p>The last component is the upper mounting clip. I left it a looser fit to the tablet and padded it with a small foam tab to prevent scratching the tablet itself.</p><p>All parts when mounted are meant to be used with T-nuts. The tolerances are tight on the extrusion, so I did not need to use them. This will need to be slid on the extrusion from one end, since it does not clip over the face.</p><p>I use this on an Ender 5 Plus as a terminal for Octoprint at the machine.</p><p>I also included a STEP file of the split version to allow editing sizes for other devices.</p>