2022 Winnebago Ekko Latch Spacer Ring

thingiverse

This part adds a 2mm gap between the outdoor latches and door on a 2022 Winnebago Ekko to prevent the risk of scratching the door. To do this installation you will need 15 mm wrench and a 27 mm deep socket to remove & reinstall the lock. These have not been tested with PLA but in my opinion should work fine since there's no opportunity for it to warp in high heat. ABS, PETG, or other high heat & water resistant filaments would without a doubt be better options though. These spacers fit very snug so if your printer is squishing the first layer too much (elephant's foot) you might need to file it down to fit or scale up the print a bit. A well calibrated printer should create a nice fit.