2022 F1 1:24 Scale RC Car

thingiverse

This is a 1:24 scale 2022 Formula One radio-controlled car. The car is based on the upcoming 2022 F1 regulations but built as a small RC car. The model is my own design, not based on a particular team's car but I used the aesthetics of the concept car the FIA previewed in 2019. This model is mostly three-dimensionally printed however some parts are not. To make the car you will need: 1x M3 nut 1x M3 x 8mm 2x M3 x 10mm (cut off head) / cut M3 rod 2x M3 nylon locking nuts 2x #6 hex nuts 2x #6 hex keps nuts 2x #6 washers (optional) 1x 6-32 x 3" threaded rod 2x 1/4" OD x 1/2" long nylon spacer 2x 1/8" x 1/2" carbon/brass rod 1x 1/8" x 5/16" carbon/brass rod 1mm OD cable (steering linkage) 1x Tamyia JR G13 & 8T PINION GEAR SET Superglue You also need the following electronics: 1x Turnigy nano-tech 300mAh 2S 35~70C Lipo Pack 1x 130 type DC motor 1x 10 Amp Brushed ESC 1x Radio transmitter and receiver (I use a Spektrum STX2 radio and receiver system) 1x JST B2 female connector 1x Turnigy TGY-0025 Digital Nano Servo These electronics parts are the ones that I use and that I've found to work the best. The RC receiver needed to be smaller, so I took it out of the plastic shell and trimmed the connectors down and soldered to the board. I haven't had any failures yet.