2020 Ultra light LED strip clip (8mm)

thingiverse

These are super small LED clips that will hold an 8mm LED strip (cob light strip in my case) at a roughly 45° angle to light up the print bed. They're set back so you can't look into them from above, reducing glare. Despite that, they will fit fine with an enclosure wall behind them. Simply slide the strip into them from the side and then clip them into the extrusion from below. Only 8mm strips will fit. You can leave the backing tape on. Note that I used PETG and a 0.4mm nozzle, since they're fairly small, you need to print them slow. Arachne tried to make the clip portion a single, thick line, which didn't work out at all, so slice using classic mode if you can.