2020 LED strip holder Kossel Delta

thingiverse

I attempted to print the holders from matrixFLYER, but they're not designed for use with t-nuts. The T-nut was resting against the protrusion of the model and wouldn't allow me to pull the holder all the way into place. I decided to take a closer look at the detail and draw it completely in the program myself. The lower part remained unchanged as a guide, but I made some adjustments to the upper section so the T-nut wouldn't interfere with the model's surface. It turned out perfectly! Important Note: This 3D printed model must be created using ABS plastic only! LEDs 3050 are known to produce excessive heat - over 80 degrees! This level of heat deforms PLA plastic, making it unsuitable for this project. I'll try to figure out a way to dissipate the heat from the LEDs. Perhaps I can improve the design itself.