2019 Dodge Ram switch console

thingiverse

I'm going to be installing a Mopar brake controller behind the switches in my panel so I needed to create a low profile design that wouldn't interfere. The picture shows the low profile version printed with grey PETG. The new low profile design fits perfectly with the brake controller, as shown in the updated picture. I made some very minor changes to v2 of the tray/insert - it's now slightly thicker and catches the tray much better at the bottom. I also changed the material from PLA to silver PETG (240c/80c). The PETG worked out great, with no melting despite being printed at the same temperature as PLA. I had previously re-printed in PETG after discovering that PLA warped/melted in the summer heat. This console holds 6 standard toggle switches that can be found on eBay to control lighting or other things. The ones I ordered were from eBay: https://www.ebay.ca/itm/12V-20A-Blue-LED-Car-Boat-Push-Button-Rocker-Switch-4x4-for-ARB-Carling-Style/223533670899 I made this for my 2019 Dodge Ram 1500 Warlock edition, but it will likely fit many other vehicles. The idea was to have the switches within easy reach, require no modifications to the console and be easily removed without a trace if necessary. It sits in the little space under the climate controls (see pic) and is a pressure fit that relies on the rubber molded 'cup' to hold it in place. Wires are easily run to it and can be easily removed without effort by using connectors. I printed it in PLA, but I'm considering re-printing it in PETG if the summer heat becomes an issue (will advise). A blank model is included to cover up any holes that are unused.