2017 Rav4 Cell Phone holder or as a Stand-Alone Iphone Holder

cults3d

Update: 03/31/22 I did a little stitch work on the mesh as it was weak in one place. After using this for several months on my desktop, my cats have rubbed against it enough that it showed that I needed to do a little stitching. If you have an issue you don't need to reprint this. E6000 Flexible Clear adhesive is great on, especially on TPU. This cell phone holder works great on a desktop or in my Rav4 as it is more cat proof as it is more stable than most holders. This was made for my IPhone 11 with a thicker Otterbox case with a Pop-cap attached. I made it wider and longer for wider for easier access. I should have taken the measurements and started from scratch as what I originally wanted was something that fit into the triangular 'slot' in the Rav4 with something that fit like a glove. But I didn't and it would have taken a lot of time to determine the angles of the corners as the slot's walls are angled. This remix reduces a bit of material but the original height is back. I also added back the ability to run a cable from the phone to etiher the front of the phone or to the back of the phone. I added two holes to allow sound escape from the speakers on the bottom of the unit. I personally don't see the back hole as usable as it would put a lot of strain the the lightening connector. To Print: This does not require supports. and should be made in PETG not PLA. I recommend the 40% infill or more as I printed at 25% infill and while I was trying to test out the fit I snapped the top half partially off. I am printing this also in TPU as I write with the following settings. While there is going to be an issue with bridging which I may have to increase my bottom walls I don't think that it will impact the print. I'll update my results later. No infill. With the TPU I'm just making a flexible shell. Walls: 4 Top/Bottom layers: 4