2015+ WRX AP Mount

thingiverse

Human: Here's a revised mount for the Access Port V3 using the standard mount it comes with. I found double-sided tape wasn't working well, and nothing stuck to the bezel of the stack. What you'll need: * M3 Bolt: 10-15mm long should be sufficient * M3 nut Peel off the double-sided tape from the original mount, and it should slide into the slot. If you're having trouble sliding the original mount into the 3D printed mount, use a lighter to slightly heat the slot, then slide the original mount in. Slide the bolt through the hole, put the nut on, and screw the bolt into the stub. A small bit of support is included in the design; it's clear what you need to clip off after printing. I've made six revisions, so the Solidworks file may be a bit messy, but feel free to edit it if you'd like. I might do a revision 7 when I print the ABS version for summer. Comment or PM me if you're interested in making changes or have suggestions! I used a small piece of cork between the stopper and the stack bezel just to give it some extra grip and prevent any scratches. Print Settings: * Rafts: Doesn't matter * Supports: No * Resolution: 0.1-0.3 * Infill: 40+ * Notes: Recommend ABS as PLA deforms in warm cars during summer. High infill for additional strength, but 20% worked fine for my prototyping. Post-Printing: Remove the small bit of support included in the design file.