2000-2007 Mitsubishi Lancer 2.0L Cold Air Intake (Non-Evo)

thingiverse

YOU MUST PRINT WITH PETG OR SOMETHING THAT CAN HANDLE HEAT AS WELL OR BETTER THAN PETG!!!!!!!!!!!!!! The battery must be moved to the trunk to make room for the pipe to go down into the bumper on this particular car. I also had to use a grinder to make the hole big enough, but that was most likely only specific to this vehicle. I only cut into non-structural sheet metal. It is easy to figure out where to cut once you have the headlight off. You will need to buy two 3" rubber couplers and a cone filter with a 3" opening. You will also need to buy 4 bolts & locking nuts, and a piece of flat aluminum bar from Home Depot or Lowes to create the metal support piece that connects to the MAF adapter down to the old air filter box mount. The printed coupler will be JB Welded on to the straight side of the turn piece and the short straight piece. The short straight piece goes down into the bumper and the cone filter is mounted to it. The long straight piece is the one that connects to the MAF adapter on one side and the turn piece on the other side. This intake might fit other vehicles but I have only tested it for the 2000-2007 Mitsubishi Lancer 2.0 (Non-Evo).