.200" (XL) Pitch,26 Teeth, 8.2mm Bore, 2 Flanges / With Hub

thingiverse

Design a customized drive system by utilizing the features available at http://www.thingiverse.com/thing:16627, generated using Customizer on http://www.thingiverse.com/apps/customizer/run?thing_id=16627. Follow these step-by-step instructions: Utilize the specified settings: - Main rod diameter (m3_dia): 3.5 - Pulley base height (pulley_b_ht): 8 units - Number of teeth (teeth): 26 pieces - Retainer height (retainer_ht): 1.5 units - Additional tooth width (additional_tooth_width): 0.2 units - Use a retainer: yes, quantity: 1 unit - Attach M3 nut with hex key (m3_nut_hex): yes, count: 1 - Pulley top height (pulley_t_ht): 12 units - Attach M3 nut flange to the system (m3_nut_flats): 5.9 units long - Height of idler component (idler_ht): 1.5 units high - Distance between nut shafts and main rod axis (nut_shaft_distance): 1.4 units apart - Shaft connected directly to motor core: yes, count: 8.2 - Base diameter of pulley part (pulley_b_dia): set at 20 units - Angled position of nuts and flanges (nut_angle): place in a vertical angle, quantity: 90 degrees total usage allowance for entire build or assembled configuration on production line including safety margins for precision quality Profile depth specification required within component build to include idler placement on structure according to plan (profile): add this level with all its subcomponents so it remains accurate from bottom layer up through center, which gives user perfect visualization tool also aiding during fabrication processes Quantity needed of these hex heads/nut fittings for attachment points in production environment only 1 no_of_nuts Key details for this piece's geometry and internal component measurements where necessary (m3_nut_depth) need adding as depth setting now set to an allowance higher amount total height calculated when completed by: total system including subcomponents' built-in components at this point is precisely placed accurately positioned properly located measured and inspected before production for precision in accordance. Also included should be details regarding extra tooth addition if not yet applied in design with its specific requirements like (additional_tooth_depth): depth, length added units here as specified: