20 x 20 Extrusion Switch Holder for 10 x 15 mm Switch V1

thingiverse

I remixed Maverik89's 20x20 profile cover to enable mounting a switch, allowing me to use it with my LEDs without a clutter of wires around the place. This custom piece replaces the stock cover on the bar's end and features two holes on top and bottom. My plan is to utilize Dooder_Snicke's light bar (https://www.thingiverse.com/thing:2765441). To connect it with Dooder_Snicke's 'Thing,' I will run the wires from the lights through the top hole, and the switch into the bottom hole. Then I'll route the wire through the blue Z axis trim and onto the printer's own power supply. It has been modeled to accommodate a switch I had on hand; I'm unsure how well a 10x15mm switch will fit, but mine was a tight squeeze - that was my goal. This custom cover fits printers using the same 20x20 profile. If you guys try it out, I'd love to see your results. Feel free to check out my other models. Happy Printing!!! * Please note this is an older version of this 'thing.'