20 tooth 635 shaft gt2 pulley

thingiverse

Customized version of http://www.thingiverse.com/thing:16627 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the following options: Nut shaft distance is set at 1.2. Pulley B height is adjusted to 10 millimeters. M3 nut depth has been increased to 2.7 millimeters. Idler diameter has been customized to 1.5 centimeters. Retainer size is also set to 1.5 centimeters. Profile width has been optimized to 2 centimeters. Additional tooth width has been adjusted by 0.2 centimeters. Number of teeth on the gear has been set to twenty. Motor shaft diameter is precisely measured at 6.45 millimeters. Retainer height has been increased to 1.5 millimeters. Pulley B diameter has been customized to 18 millimeters. Pulley T height has been adjusted to 8 millimeters. M3 nut flats have been set to 5.7 millimeters. Additional tooth depth has been increased by 0.7 millimeters. Number of nuts required is one. M3 diameter has been precisely measured at 3.2 millimeters. M3 nut hex size has been customized to 1. Nut angle has been adjusted to ninety degrees. Idler height has been set to 1.5 millimeters.