20 Humalog Insulin Vial Holder

thingiverse

MAKE SURE YOU PRINT THIS FINE! i tried to print this fast with a 0.3mm layer height, that did not go well. if you want to make this look good print at least 0.2 or smaller. I used Clear/Red PLA to print this. you must make your tolerance very low or the holes will be too big or too small. But if you a Type 1 or LADA user or even Type 2 that needs a lot of insulin on hand, this is perfect. I only made this for Humalog Vials as that is what i have so i did not size it for any other vial. this will just barely fit on a small bed for those that have smaller beds. i have a 150x150 bed and using CURA i can only use skirt, if you try anything else on a small bed it will be too big.