$20.00City of Life #1 - Scenery Set

myminifactory

Models from this pack are prepared in two versions - for resin and FDM printing. Both versions are of the same scale, but the FDM versions are slightly larger - their size is optimally adapted to the printing technology. The resin print versions are a kind of challenge and experiment - I prepared them entirely for support-free printing, directly on the built plate. They have properly sculpted holes limiting the suction power, they are also properly hollowed to use as little resin as possible. Each model (except the easiest ones) for resin printing also has a special "pad" that helps to remove the model from the built plate after printing. All resin models have been tested on the Elegoo Mars Pro 2 (using standard speeds - I suggest not to use vroom). This printer has a slightly larger working area than the older models of printers, so if necessary, the models can be reduced in the slicer by a few percent, so that the model fits on the built plate. I have not tried to enlarge these models (I only have Mars Pro 2, I can only dream about buying a larger printer), so you do it at your own risk. In short - both FDM and resin models are "click, drop, slice, print". No need to add any supports, hollowing, holes. Everything is ready for printing. You can see the effects in the photos above.   None of these models requires the use of any supports (including resin models).   NOTE: The miniatures presented in the pictures (dwarf, female druid and warrior) are made by Duncan "Shadow" Louca and are shown only for the scale. They are used with the knowledge and consent of the author. They are not included in the presented product.