2 Euro Coin Magazine Dispenser

cults3d

I created my own design since none were available. The prototype holds 20 coins worth approximately €40. The spring used has dimensions: length 57/11mm, inner diameter (ID) 13mm, outer diameter (OD) 15mm. Any spring with an OD of less than or equal to 20mm, an ID greater than 13mm, and a length greater than 55mm will likely work well. Less compression generally results in fewer coins. The top component stays in place due to friction alone; however, I secured it with a thin bead of super glue for added stability. Be cautious not to attach the slider, as this can occur if you insert two coins before applying the adhesive. Only the top component should be printed with supports. For further information on how to assemble and use this prototype, please refer to the video at https://www.youtube.com/watch?v=jxN0c0DlGeM.