2.5 inch micro quad

thingiverse

This is one of my test designs I came up with. It's tailored to fit a 1408 motor with 12mm diameter mounting holes. This design is specifically for use with 2.5 inch props. My setup was able to carry a GoPro 7 Black and completely overpower the battery, which had 1500mAh of capacity and an 80C discharge rate, weighing in at 190g. After two minutes of flight time, it landed safely with 47 percent of its battery remaining. Later on, I'll post pictures of my tested design. I used 25mm M2 aluminum spacers for the build. There are holes provided for a 20x20 stack and a 30x30 configuration as well, but be cautious when placing your electronics to avoid any propellers getting in the way. I opted to assemble mine upside down so that my motors ended up being mounted upside down.