1Phasen Schiene Befestigungsadapter (SLV / Eutrac)

thingiverse

A mounting adapter like this one from LED Leuchtstoffröhren is needed for 1Phase tracks, such as the SLV: https://amzn.to/2K1GRLg. Note: This is not an inverter, a pendant light adapter like this one is required: https://amzn.to/2SGSDyC. The mounting adapter consists of two parts: the clip and the turnable pin (locking mechanism). To achieve the best printing results and avoid problems with hidden support structures, it makes sense to print the clip in two parts. You can then secure them with 2x M3 16mm screws or with a strong adhesive. The clip should be printed without any support structure if it is printed in two parts. It's also possible to print the clip as one piece and remove the support structure, but I found that this takes much longer than printing the two separate pieces together. The continuous 10mm hole can be used to fix the parts after gluing until the adhesive has hardened. The pin can be inserted and removed later without having to disassemble the entire component. Print the pin with a support structure. I printed everything in 0.3mm layer height, which is sufficient for use as a mounting adapter. Note: This component will be used in an electrical system, so please do not use conductive filament (carbon fiber reinforced or graphite containing filament may not be optimal). Only electricians should install the adapters, and make sure to turn off the power before installation and check that there is no electricity on the part after installation. I am not responsible for any damage! If you're unsure about any step: don't do it, or let an electrician handle it. It's better to invest a few dollars than to get electrocuted or risk injuring others. This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/1EGFfDx1Db2