1mm nozzle version of Crazy FAST Voodoo Headband Prusa Faceshield compatible

prusaprinters

<p><strong><em>UPDATE</em></strong> There is a new version: <a href="https://www.prusaprinters.org/prints/29052-1mm-voodoo-faceshield-v34">https://www.prusaprinters.org/prints/29052-1mm-voodoo-faceshield-v34</a></p> <p>This print uses Voodoo magic and a 1mm nozzle to enhance print speed while still producing a good quality finish.</p> <p>ATTENTION!!!<br/> These files only slice with Cura 2.4 which is not available anymore. but you can Download my installation from here:<br/> <a href="https://we.tl/t-vpmwlS0oSR">https://we.tl/t-vpmwlS0oSR</a><br/> Also here are curaprofiles which I highly recomment as a basis:<br/> <a href="https://we.tl/t-jUbkrpgmb8">https://we.tl/t-jUbkrpgmb8</a></p> <p>Cura 2.4 is needed for the Voodoo to work. The bug breaking my magic is unfixed for years now but here is all you need to<br/> print face shields crazy fast.</p> <p>It uses the "surface mode" feature from the experimental section which moves the nozzle on the middle of the surface instead of inside the boundary's of a closed object. With that I have almost full control over the movement of the nozzle. It is my specialty to make models that can be printed in one go without traveling at all. So you can print fast and still have a good finish.</p> <p>There is also a version for a 0.4mm nozzle:<br/> <a href="https://www.prusaprinters.org/prints/28342-crazy-fast-voodoo-headband-prusa-faceshield-compati">https://www.prusaprinters.org/prints/28342-crazy-fast-voodoo-headband-prusa-faceshield-compati</a></p> <p>The print time for the .4mm nozzle is about 40 minutes and for the 1mm nozzle about 20 minutes</p> <p>And please take the time to rate and comment</p> <p>The attached gcode is for a Anet A8 and PETG<br/> If you print in PLA there is gcode for that in the "user print files"<br/> the gcode is for a 1mm nozzle. But I cant select that...</p> <hr/> <p><strong><em>Update</em></strong> V2.0 April 6th 2020<br/> There was a fatal bug in the design wich effected the stability when printing in PLA. if you printed the first version in PLA check your parts. the "flaps" kept breaking off while putting the shield on. PETG parts should be fine. New version is testet with PLA and while PETG is still much more flexible using PLA is now exeptable.</p> <hr/> <p><strong><em>Update</em></strong> V2.2 April 7th 2020<br/> Just rounded an edge and updated the curaprofile a bit.</p> <h3>Print instructions</h3><p>Layer height: 0.625<br/> line width: 1<br/> outer wall speed: 30<br/> fan: off<br/> surface mode: surface<br/> spiralize outer contour: true<br/> z seam alignment: user specified<br/> z seam x: 100<br/> z seam x: 0</p>