1987 Nissan D21 Hardbody Ashtray

prusaprinters

<p><strong>This model has not been test fitted yet, I will update here when it is but side-by-side looks promising.</strong></p><p>Captured using a Revopoint Mini, the STL uploaded is significantly lower resolution as the scanned file was half a gig and didn't seem necessary to keep the fine details but I can send the scans and/or higher res file if you need them. The model has been simplified to a degree but some slight artifacts remain that could stand to be cleaned up, for example the right side has some texture due to one of the scans not overlapping perfectly and leaving some noise.&nbsp;</p><p>Intent on scanning this is to make an Ashtray Based cupholder similar to the one found <a href="https://www.thingiverse.com/thing:2304131">here</a> by hackawayjr. Once test fitted I will likely just flatten the handle portion and add the pegs for the cupholder.</p><h5>Print Settings</h5><p>Supports: Touching Buildplate</p><p>Infill: Shouldn't matter, the example was done with 20%, higher should prevent any pillowing.</p><h5>Support Removal</h5><p>This one is going to take a while as there are a TON of supports (see picture below). The supports are not difficult to remove but they are extremely time consuming. I was able to remove all of mine (printed in PETG for the example) with flush cutters, a set of needle nose pliers, and a small flathead screwdriver to get into the handle area. I started at the front left corner of the handle and worked my down the side and underneath all the way around.</p><figure class="image"><img src="https://media.printables.com/media/prints/299644/rich_content/5b0ac8e4-9fca-4982-bb6c-370409659461/img_0339.jpg#%7B%22uuid%22%3A%22995c5ead-e2ab-455e-9ed6-84d0c4e4687a%22%2C%22w%22%3A5184%2C%22h%22%3A3888%7D"></figure><p>&nbsp;</p>