1978 - 1981 Camaro Trans Am Tail Light Retainer Spin (Wing) Nut GM

thingiverse

If you don't have a printer, there's no need to worry! You can have eight of these nuts delivered right to your doorstep for under twenty bucks. Click on the "Order This Printed" button and select PLA or ABS plastic. The center hole is 6mm in diameter, while the base measures 30mm wide. GM tail light retainer nuts are designed for use on specific models, including: 1978, 1979, 1980, 1981 Camaro 1979, 1980, 1981 Trans Am 1979, 1980, 1981 Firebird These nuts screw directly onto the studs that protrude from the back side of the tail light and poke through the sheet metal into the trunk compartment. For more information, visit https://fbodywarehouse.com/store/1978-1981-camaro-trans-am-tail-light-retainer-spin-nuts-gm.html. A notable addition is that these nuts may also work on various other GM vehicles, such as: 1978, 1980, 1981, 1982, 1983, 1984, 1985, 1986, 1987 Grand National Buick Tips for printing and installation: - Use a 13mm or half-inch wrench to fit over the end, but it's recommended to tighten the nut using only your fingers. - Print the model with 100% infill. - Consider adding a rubber washer with a 3/8 interior hole and a 1 1/4 outside radius for added protection. You can find such washers on Amazon at https://www.amazon.com/Hard-Find-Fastener-014973211851-Washers/dp/B00L1IUQHW/. I spent a lot of time searching for new wing nuts to connect my tail lights to my 1978 Camaro, so I decided to create some myself.