18mm Proximity Sensor Clip for Anycubic Kossel

thingiverse

Human: Anycubic Kossel Proximity Sensor Clip Upgrade.\nI advise securing the clip with a small amount of glue inside to keep it in place while moving.\nA new version is now available, offering improved stability and strength, so gluing may not be necessary.\nIt's recommended that you band the sensor cable with your heater block cables and then secure them to an arm, leaving enough slack for any movement. This prevents tugging on the sensor.\nI've included my custom firmware (based on 20170228) pre-configured for linear Plus, N/O inductive sensor mounted at the rear of the heater block, X = Front L, Y = Front R, Z = Rear.\nAfter installation, you'll need to fine-tune "Z_PROBE_OFFSET_FROM_EXTRUDER":\n• Run G29\n• Place a sheet of paper on the bed\n• Lower the head until it touches the paper with some drag friction\n• Adjust "Z_PROBE_OFFSET_FROM_EXTRUDER" using the Z position displayed on screen\nIf "Z_PROBE_OFFSET_FROM_EXTRUDER" seems ineffective, set the Z offset like this:\n• Run G29\n• Place a sheet of paper on the bed\n• Lower the head until it touches the paper with some drag friction\n• Get the current offset value by sending M851\n• Add that value to the Z position displayed on screen\n• Send M851 Z-xx.x (where xx.x is your new value)\n• Save the new value with M500\nIf you're using an N/C sensor, change "Z_MIN_ENDSTOP_INVERTING" to true.\nPrint Settings:\nYes, supports printing.