18mm auto level sensor support for Anet A8 right side

thingiverse

A sturdy and reliable sensor support is designed specifically for the Aner A8 and compatible with LJ18A3-8-Z/BX or any other 18mm diameter sensor. It's strategically positioned on the right side to provide easy access to the extruder while avoiding a collision with the heat bed cable. The downside is that it is situated further away from the sensor compared to those located near the fan. For autolevel instructions, see: https://3dprint.wiki/reprap/anet/a8/improvement/autobedleveling An extended fan duct can be found on Thingiverse at http://www.thingiverse.com/thing:2168430 and also at http://www.thingiverse.com/thing:2037771 My Marlin RC8 settings (which should work for Skynet as well) are listed below: Travel limits after homing (measured in mm) are set as follows: #define X_MIN_POS -33 #define Y_MIN_POS -10 #define Z_MIN_POS 0 #define X_MAX_POS 220 #define Y_MAX_POS 215 #define Z_MAX_POS 240 Set the boundaries for probing by defining where the probe can reach: #define LEFT_PROBE_BED_POSITION 35 #define RIGHT_PROBE_BED_POSITION 200 #define BACK_PROBE_BED_POSITION 170 #define FRONT_PROBE_BED_POSITION 20 X-probe offset from extruder is set to 65, which means -left +right [of the nozzle] Y-probe offset from extruder is set to -36, meaning -front +behind [the nozzle] Z-probe offset from extruder is set to -2.90, indicating -below +above [the nozzle]